NORTH BENZ V3 6X4 Tractor Truck
More Info - NORTH BENZ V3 6X4 Tractor Truck
Beiben Tractor Truck/North Benz Tractor Truck
Mercedes Benz Technology
High Quality
Best After – Sales Service
BV TUV SGS
Beiben V3 6×4 420hp Tractor Truck/North Benz Tractor Truck
Mercedes Benz Technology Beiben Truck LHD 6×4 V3 EUROIII Weichai Engine 400hp 10wheeler 40t Tractor Truck
We have the distributor privilege for Beiben Truck whole truck series,. We could provide tractor truck dump truck and other special trucks with high quality and competitive price, because we get directly support from the Beiben Trucks Group Co., Ltd.
NORTH BENZ V3 6X4 Tractor Truck | |
Model | ND42501B34J7 |
Driver’s cab | Long High cabin, two sleepers with A/C |
Engine | Maker: WEICHAI |
Diesel 4 stroke direct injection diesel engine, 6 cylinder in-line with water cooling,turbo-charging & inter cooling | |
Engine model: WP10.380E32
EURO II/EUROIII emission standard |
|
Maximum output:380hp@2200rpm | |
Number of cylinder:6 | |
Displacement: 9.726L | |
Clutch | Single-plate dry coil-spring clutch,diameter 420mm,hydraulically operating with air assistance |
Transmission | Fuller 12JS200T transmission. |
Front Axle | Benz 7.5tons drum brake |
Rear Axle | Benz type double reduction drive axle, ratio=5.2 |
Steering | TAS85 |
Wheel & Types | Rims:8.5-20 |
Tyre:12.00R20 | |
Optional: 12R22.5//315/80R22.5 | |
Radial tire is optional | |
Electrics | Operating voltage: 24V,negative grounded |
Dimensions in mm | Wheel base : 3450+1450 |
Overall size: 7050x2500x3840 | |
Weight in kg | Kerb. mass: 8800 kg |
Total mass: 40000kg | |
Performance | Maximum driving speed(km/h) 90 |
Fifth wheel | 16070kg |
The manufacture reserves the right of technical alteration/ change for better improvement prior notice |
A dump truck is a truck used for transporting loose material (such as sand , gravel , or dirt ) for construction . A typical dump truck is equipped with a hydraulically operated open-box bed hinged at the rear, the front of which can be lifted up to allow the contents to be deposited on the ground behind the truck at the site of delivery. They are also known as tipper trucks.
A standard dump truck is a truck chassis with a dump body mounted to the frame. The bed is raised by a hydraulic ram mounted under the front of the dumper body between the frames, and the back of the bed is hinged at the back to the truck. The tailgate can be configured to swing on hinges or it can be configured in the “High Lift Tailgate” format wherein pneumatic rams lift the gate open and up above the dump body.
Common configurations for a standard dump truck include the six wheeler which has one powered rear axle, the ten wheeler with two powered rear axles, the tri-axle with one lift axle and two powered axles, and the quad with two lift axles and two powered axles.. The largest of the standard dump trucks is commonly called a “centipede” and has seven axles. The rear two axles are powered, the front axle is the steering axle, and the remaining four are lift axles. The intermediate axles are present to support the weigh over the length of the chassis and sometimes to provide additional braking power. The short wheelbase of a standard dump truck makes it more maneuverable than the higher capacity semi-trailer dump trucks.
An articulated dump truck, or “Yuke” in the construction world, has a hinge between the cab and the dump box, but is distinct from semi trailer trucks in that the cab is a permanent fixture, not a separable vehicle. Steering is accomplished via hydraulic rams that pivot the entire cab, rather than rack and pinion steering on the front axle. This vehicle is highly adaptable to rough terrain. In line with its use in rough terrain, longer distances and overly flat surfaces tend to cause driveline troubles, and failures. Articulated trucks are often referred to as the modern scraper, in the sense that they carry a much higher maintenance burden than most trucks.
Yes. We offer a guarantee to 60,000 Km or 1 year (whichever is reached first).
Yes, it is possible. It is installed on the opposite side of the standard tank.
Yes. It can be added next to the batteries.
Our dump trucks are imported fully built and finished. The dumper is built and fitted on the truck in the manufacturer’s factory. We receive our dump truck as a turn-key product.
It is linked to the main engine.
Yes. We offer 24 hour service to our customers across most of the country. A maintenance car with an Engineer and spare parts are available for our customers all the time.
The dumper reaches 45 degrees and tips to the back only.
The Jack is 3.5 inches.
Yes. A/C is a standard option. Bed is also installed in our tractor heads
Yes. It can be added next to the batteries.
Ready to take on any job, any time.
Just give us a call.
Send Us a Quick Message
How to benefit from this offer:
To make most of this offer, get in touch with us through any of the following:
Fill the enquiry form given below and our customer service team will get back in touch with you.