20 CBM beiben 6*4 drive waste management truck

Beiben trucks are characterized by high maneuverability and strength with sufficient standby power, high capacity and excellent sudden loading.
Beiben truck is still reliable for its high efficiency under severe conditions, such as altitude, severe cold, etc.

The new generation BEIBEN 20 CBM Refuse Garbage Compactor is mainly used in collecting and transporting the scattering refuse of the urban area,

community, factory, schoolyard.

The refined appearance, the fully sealed truck body, the sealed door of the beiben 6*4 drive garbage compactor truck body is able to prevent the sewage from leaking during transporting so that secondary pollution is avoided. The imported hydraulic units are of the best quality with convenience and reliability. Automatic reverse unloading, clean and quickly.

Manufacture and sell commercial vehicles (trucks and buses) of all types required in the Egyptian market. Offer high quality products in all our sectors, whether; spare parts or any of our trucks and products.

More Info - 20 CBM beiben 6*4 drive waste management truck

Key Features:

◆ Easy operation and easy maintenance!

◆ With imported PLC (programmable logic controller) for integrated control

◆ Collecting refuse in sealed condition, equipping with waste water tank, preventing re-pollution.

◆ Substantial truss structure, payload distributed appropriately in hopper lip, no deformation.

◆ Automatic controlled throttle and hydraulic safety valves, avoiding power wastage, lower oil consumption.

◆ Automatic and manual operating control, improving operation reliability

◆ The engine power output control, namely the throttle control, can realize fully automatic control through the electronic throttle controller, so the engine will automatically change to a higher speed or idle speed under different operating modes, thus avoiding power loss and system heat to reduce fuel consumption and realize good economical efficiency.

◆ Both automatic and manual control modes are available. Two operation boxes mounted in the cab and at the rear side of the vehicle respectively can facilitate the operation.

◆ Different bin (hopper) tipping mechanisms are provided for different users to select in accordance with different garbage collecting

A dump truck is a truck used for transporting loose material (such as sand , gravel , or dirt ) for construction . A typical dump truck is equipped with a hydraulically operated open-box bed hinged at the rear, the front of which can be lifted up to allow the contents to be deposited on the ground behind the truck at the site of delivery. They are also known as tipper trucks.

A standard dump truck is a truck chassis with a dump body mounted to the frame. The bed is raised by a hydraulic ram mounted under the front of the dumper body between the frames, and the back of the bed is hinged at the back to the truck. The tailgate can be configured to swing on hinges or it can be configured in the “High Lift Tailgate” format wherein pneumatic rams lift the gate open and up above the dump body.

Common configurations for a standard dump truck include the six wheeler which has one powered rear axle, the ten wheeler with two powered rear axles, the tri-axle with one lift axle and two powered axles, and the quad with two lift axles and two powered axles.. The largest of the standard dump trucks is commonly called a “centipede” and has seven axles. The rear two axles are powered, the front axle is the steering axle, and the remaining four are lift axles. The intermediate axles are present to support the weigh over the length of the chassis and sometimes to provide additional braking power. The short wheelbase of a standard dump truck makes it more maneuverable than the higher capacity semi-trailer dump trucks.

An articulated dump truck, or “Yuke” in the construction world, has a hinge between the cab and the dump box, but is distinct from semi trailer trucks in that the cab is a permanent fixture, not a separable vehicle. Steering is accomplished via hydraulic rams that pivot the entire cab, rather than rack and pinion steering on the front axle. This vehicle is highly adaptable to rough terrain. In line with its use in rough terrain, longer distances and overly flat surfaces tend to cause driveline troubles, and failures. Articulated trucks are often referred to as the modern scraper, in the sense that they carry a much higher maintenance burden than most trucks.

Yes. We offer a guarantee to 60,000 Km or 1 year (whichever is reached first).

Yes, it is possible. It is installed on the opposite side of the standard tank.

Our dump trucks are imported fully built and finished. The dumper is built and fitted on the truck in the manufacturer’s factory. We receive our dump truck as a turn-key product.

Yes. We offer 24 hour service to our customers across most of the country. A maintenance car with an Engineer and spare parts are available for our customers all the time.

The dumper reaches 45 degrees and tips to the back only.

Yes. A/C is a standard option. Bed is also installed in our tractor heads

Ready to take on any job, any time.
Just give us a call.

Send Us a Quick Message

How to benefit from this offer:
To make most of this offer, get in touch with us through any of the following:

Fill the enquiry form given below and our customer service team will get back in touch with you.

    1 Comment

    Leave a Reply